MCNOs/CdS双效光催化剂的制备及其性能研究

水热合成法制备了不同磁性纳米洋葱碳(MCNOs)负载量(0%、1%、3%、5%)的MCNOs/CdS光催化剂。并通过X射线衍射分析(XRD)、扫描电子显微镜(SEM)、傅里叶红外光谱(FT-IR)、X射线光电子能谱(XPS)、紫外可见光光谱(UV-Vis)、磁滞回线测定仪(VSM)对其进行表征,探究了MCNOs负载比例对催化剂在可见光下降解RhB性能及机理的影响。结果表明,MCNOs能有效提高CdS的光催化效果,复合3%MCNOs后降解率为96%,与纯CdS相比降解率提高了30%,磁性分析表明,其具有良好的顺磁性并能实现催化剂的有效回收。MCNOs/CdS在可见光下催化降解RhB的一级反应动力学直线有较好的拟合度,表明制备的催化剂有较好的催化活性。     

密度泛函理论方法研究填料表面对聚合物摩擦化学的影响

采用超声分散法制备出氧化铝、高岭土、氧化硅/聚四氟乙烯复合材料, 使用线性往复摩擦磨损试验机对比三种复合材料的摩擦学性能. 结果表明 质量分数10%的氧化铝、高岭土能将聚四氟乙烯的磨损率降低约4个数量级, 而氧化硅仅能降低约3个数量级. 对金属对偶表面形成的转移膜的形貌和化学成分进行分析发现 氧化铝、高岭土/聚四氟乙烯在金属对偶面上形成了高度羧酸盐化的转移膜. 用密度泛函理论对三种填料表面上碳氟分子吸附过程进行模拟, 结果显示氧化铝、高岭土表面的路易斯酸性位点促进了碳氟分子的脱氟过程, 产生了更多的羧酸螯合物的中间产物; 氧化硅缺少路易斯酸性位点, 因此不能促进高度羧酸盐化的转移膜形成.     

富晶格位错的多孔铋纳米花高效电还原二氧化碳制甲酸盐※

二氧化碳转化已成为现今世界研究的热点. 本工作采用原位电化学转化的策略, 将简单溶剂热法合成的层状甲酸氧铋纳米花(BiOCOOH NFs)还原为带有大量晶格位错的多孔铋纳米花(p-Bi NFs). 研究结果表明, p-Bi NFs电催化二氧化碳转化为甲酸盐具有较小的过电位(436 mV). 在–1.8 V(相对饱和甘汞电极, vs. SCE)时, 甲酸盐的分电流密度(j_formate)高达24.4 mA•cm^-2, 法拉第效率(FE_formate)为96.7%, 且在超过500 mV的宽电位窗口内FE_formate超过90%, 并具有很好的稳定性. 该催化剂的高催化性能可归因于前驱体晶格坍塌和重构而形成特殊的多孔粗糙的微纳多级结构, 其表面富含晶格位错和缺陷等高本征活性位, 且具有较强的电子传递能力. 本研究为设计合成高性能的电催化二氧化碳还原产甲酸催化剂提供了新的思路.     

Controlling thermomechanical behavior of semicrystalline hydrogenated polynorbornene through the cis- to trans-cyclopentylene ratio

Though polynorbornene synthesized by ring-opening metathesis polymerization has an intrinsically all-cis configuration of the cyclopentylene backbone rings, a fraction of these rings can be epimerized to the trans configuration during hydrogenation over suitable catalysts. By varying the method of hydrogenation, semicrystalline hydrogenated polynorbornenes (hPNs) with trans levels between 0 and 36% were obtained. With increasing trans content, the glass transition temperature, melting point, and enthalpy of melting decrease modestly. By contrast, the temperature at which the hPN crystal transitions into a rotationally disordered polymorph varies strongly with trans content, ranging from 126 °C (all-cis) to 71 °C at 27% trans; at trans contents of 34% and above, no rotationally-ordered phase is observed at any temperature. The room-temperature Young's modulus shows no dependence on trans content, while the yield stress drops by 20% at 1% trans content and slowly decreases further with additional epimerization. The temperature dependence of the Young's modulus differs for trans-containing versus all-cis polymers, while the temperature dependence of the yield stress is set by the polymorph type (rotationally ordered vs. disordered).     

Nanocomposite thin film structures based on polyarylenephthalide with SWCNT and graphene oxide fillers

Investigations of nanocomposite thin films based on polyarylene- phthalide, single-walled carbon nanotubes and graphene oxide have been carried out. Using these films as a transport layer, field-effect transistors were assembled and their output and transfer characteristics were measured. The mobility of charge carriers was estimated and the obtained values are as follows: μ_PAP/GO = 0.020 cm² V^?1 s^?1 and μ_PAP/SWCNT = 0.071 cm² V^?1 s^?1.     

Ruthenium-catalyzed methoxycarbonylation of styrene

Methoxycarbonylation of styrene in the presence of homogeneous Ru catalysts is reported for the first time. Available Ru₃(CO)₁₂ together with halide source such as [bmim]Br, NaBr or LiCl represents active and easy to handle methoxycarbonylation catalyst. The key advantage of the new catalytic systems over traditional Pd catalysts is their high activity at CO pressure as low as 5 bar.     

Spectroscopic properties and bond dissociation energies of PbX,PbX±, PbX2 and PbX2± (X ​= ​F,Cl, Br,I)

Ab initio calculations have been performed to investigate some of the spectroscopic properties, like geometry, frequency, electron affinity, ionization potential and finally adiabatic bond dissociation energies (BDEs) of lead monohalides, lead dihalides and their ions viz. PbX, PbX^±, PbX₂, $\mathrm{P}\mathrm{b}{\mathrm{X}}_{\mathrm{2}}^{\pm }$ (X ?= ?F, Cl, Br, I) in their ground state at the QCISD(T)//MP2 level of theory using correlation consistent basis sets. For the validation of MP2 optimized geometry and frequency, we further obtained geometry and frequency of all the neutral and ionic systems using QCISD(T) method with the same basis sets. The BDEs of PbX₂ molecules are calculated using the BDEs of $\mathrm{P}\mathrm{b}{\mathrm{X}}_{\mathrm{2}}^{\pm }$ ions and taking ionization potential and electron affinity of various systems. The calculated values are found in good agreement with the available data. Most of the data for ionic systems are reported first time in literature.     

Chemical bonding in representative astrophysically relevant neutral,cation, and anion HCnH chains

Most existing studies assign a polyynic and cumulenic character of chemical bonding in carbon-based chains relying on values of the bond lengths. Building on our recent work, in this paper we add further evidence on the limitations of such an analysis and demonstrate the significant insight gained via natural bond analysis. Presently reported results include atomic charges, natural bond order and valence indices obtained from ab initio computations for representative members of the astrophysically relevant neutral and charged HC_2k/2k+1H chain family. They unravel a series of counter-intuitive aspects and/or help naive intuition in properly understanding microscopic processes, e.g., electron removal from or electron attachment to a neutral chain. Demonstrating that the Wiberg indices adequately quantify the chemical bonding structure of the HC_2k/2k+1H chains—while the often heavily advertised Mayer indices do not—represents an important message conveyed by the present study.